Instructions for IDTech to TXP conversion in AS4

Conversion from IDTech to TXP in Auto Sentry Petro and a New Decal

Powering Down the Auto Sentry Petro

WARNING: Failure to power off the Auto Sentry Petro increases the risk of serious bodily injury or death, and also causes the credit card reader to go into a tamper state which will then have to be replaced.

1. On the site server desktop, click on the VNC icon for the Auto Sentry Petro.
2. On the menu bar, click the Windows flag icon.
3. Click the Shutdown button.
4. Wait until a white screen appears on the Auto Sentry Petro display.
5. Open the rear door of the Auto Sentry Petro.
6. Turn off the power switch inside the Auto Sentry Petro.
7. Inside the Auto Sentry, press the blue buttons on the breakers until they click out to turn off.
8. Shut off the electricity to the Auto Sentry Petro by turning off the Auto Sentry Petro breaker inside the ICS power distribution box.

Removing Card Reader

1. Remove the plastic panel from the front door.
2. Remove the decal from the front of the door.
3. Disconnect the wires from the IDTech card reader and NFC reader.
4. Remove the IDTech card reader and NFC reader, and set aside the hardware to use later.
5. Remove the blocker plate above the card reader, and set aside the hardware to use later.

Installing the TXP Card Reader and Decal

1. Install the (2) new blocker plates where the card readers were.
2. Install the new TXP card reader where the blocker plate was located.
   NOTE: The TXP card reader must be mounted angled downward toward the back of the door.
3. Route the USB cable for the card reader to the motherboard and attach to any available USB port.
4. Attach new decal.
5. Attach plastic panel.

Powering On the Auto Sentry Petro

1. Turn the breakers on inside the Auto Sentry Petro by pressing the blue button(s) on the breakers until they click in.
2. Inside the Auto Sentry Petro, turn on the power switch to boot the system.
3. Power on the electricity to the Auto Sentry Petro by turning on the Auto Sentry Petro breaker inside the ICS power distribution box.

Please contact ICS Technical Support if any assistance is needed:

800-246-3469

File Name: INSTR0153